AR RF Microwave Instrumentation 75A250A 75W CW, 10Khz-250Mhz, Amplifier


Key Features & Specifications

  • Power output CW 100 Watts nominal, 75 Watts minimum
  • Linear @ 1dB compression 50 watts minimum
  • Gain (at maximum setting) 49dB minimum
  • Input impedance: 50ohm, VSWR 1.5:1 maximum, Type N (f)
  • Output Impedance: 50ohm, VSWR 2.0:1 maximum, Type N (f)
  • Harmonic distortion: -20dBc maximum at 50watts
  • Remote interface: IEEE-488, RS-232


The Model 75A250A amplifier is a portable, self-contained, air-cooled, broadband, solid state amplifier unit designed for laboratory applications where instantaneous bandwidth, high gain and moderate power output are required. Utilization of push-pull MOSFET circuitry lowers distortion, improves stability and allows operation into any load impedance without damage. When used with an RF sweep generator, the 75A250A will provide a minimum of 75 watts of swept RF output power. The Model 75A250A includes a front panel RF Gain Control, which permits the operator to conveniently set the amplifier's desired output level. Housed in a stylish contemporary enclosure, the unit provides instantaneous power for typical applications such as RF susceptibility testing, antenna and component testing, Watt-meter calibration and as a driver for higher power amplifiers. The 75A250A is powered by a high efficiency switching supply, with autoranging AC input circuitry which will automatically accept voltages from 90 to 135 VAC, or from 180 to 270 VAC, in the 47 to 63 Hz frequency range. The RF Amplifier stages are protected from over temperature by removing the DC voltage to them if an over temperature condition occurs due to a cooling blockage or fan failure. The digital display on the front panel indicates the operation status and any pending fault conditions when an over temperature or power supply fault has occurred. The unit can be returned to normal operation when the condition has been cleared; as with the other functions, this can be readily accomplished through a front panel switch. The unit also includes digital control for both local and remote control of the amplifier. The 8-bit RISC microprocessor controller board provides IEEE-488 (GPIB) and asynchronous full duplex RS-232 communication control of all amplifier functions.

AR RF Microwave Instrumentation   75A250A   Used   45770  

United States Buyers

Non-U.S. Buyers

Shop in Other Categories: Amplifiers 

Search for Other Products

Used AR RF Microwave Instrumentation 75A250A 75W CW, 10Khz-250Mhz, Amplifier

Buy with Assurance
  • No Surprises Guarantee
    • All units fully function tested & performance verified to factory standards
    • Certificate of Calibration & Warranty included with every unit
  • 10-Day Right of Return — double the industry standard!
  • Price Match Guarantee
  • 98% Customer Satisfaction Rating
  • Flexible Financing & Leasing Options
  • Trade-Up & Consignment Programs